Supplier Introduces The Installation Method Of Gabion Walls

10:58:31 25/04/2020

The gabion wall is also known as the ecological stone cage wall. It is a brand-new ecological protection engineering technology. It uses hot-dip galvanized steel wire with good anti-rust and anti-corrosion performance. The service life can reach more than 70 years. Good water permeability greatly meets the requirements of protection engineering design.

Let me introduce how to install the gabion walls.

1. The staggered seams of the gabion wall are in place to avoid longitudinal through seams.

2.Stand up the four sides and fasten the adjacent edges with the binding wire.When binding, wrap the binding wire around the two overlapping frame lines (when stitching the edges) or the double twisted edges of the frame line and the mesh cage (sewing grid) Grid) screw-shaped tightening to avoid regalvanizing damage, the pitch is not greater than 50mm.

3.When installing on the finished bottom net, use the binding wire to fix it to the bottom gabion mesh along the newly installed lower border, and the adjacent gabion wall mesh on the same layer should also be tied to each other so that The gabion baskets are connected together.

4. When constructing the same horizontal layer of a unit project, the gabion cages should be fully seated before starting to fill the pebbles.In order to prevent deformation, the stone filling of two adjacent gabion nets (including the same adjacent cell) The height difference should not be greater than 35cm.

5. Before installing the gabion walls, the bank slope and ground should be properly repaired, and the original shape of the bank slope should be maintained as much as possible, but there should be no obvious uplift and depression.

6. Put 10-15cm of humus soil on the masonry to facilitate vegetation growth.

After the installation of the gabion walls, pay attention to the later maintenance and repair, in order to extend the service life of the gabion walls.